Solid State Lighting Driver ICs
Aug 04, 2023Asus ProArt PA32UC 4K HDR Professional Monitor
Jul 19, 2023Global and China Automotive Electronics OEM/ODM/EMS Industry Report 2023: Amid the Evolution of E/E Architectures, the Boundary Between PCs and Vehicles will Gradually Vanish in the Zonal Era
Aug 14, 2023Biden Puts Final Nail In the Coffin For Incandescent Light Bulbs
Aug 06, 2023All you need to know about dimming
Jul 31, 2023Hacking A Non
For most of us, the solution to having a non-dimmable LED light bulb but needing a dimmable one is a simple as a drive to the store to get the right kind of bulb. But that seems downright boring, not to mention wasteful, so when [Leo Fernekes] was faced with this problem, he looked for a way to make a non-dimmable bulb dimmable.
To be fair, there was a financial aspect to this hack, too. [Leo] had a bunch of cheap non-dimmable light fixtures he wanted to put to use. He started with a teardown and reverse-engineering of a light strip, which contains little more than LEDs and a small buck converter. His analysis of the circuit led him to a solution for dimming the light: inserting a MOSFET as a shunt around the LEDs. That and the addition of a diode to isolate the LEDs from the current regulator would allow for simple PWM-control of the lights via a microcontroller.
As is typical with these things, there were complications. [Leo] found that a timing problem resulted in flickering LEDs; the fix came from adding a sync circuit that cleverly leveraged a flip-flop inside the PIC16 microcontroller he chose for the circuit. His prototype incorporates these modifications, plus an interface that supports the DALI protocol for architectural lighting control. As always, [Leo] is quick to point out that mixing line voltage into your projects is not without risks, which he takes pains to mitigate. And as is also typical for his projects, [Leo] gives just the right amount of detail to understand the theory behind his design.